Sie befinden sich hier: Startseite » Ex-proof Equipment » Safety X-Linie » Optional accessories of the Safety X-Line

Optional accessories of the Safety X-Line

EX Options Digital recorder

Digital recorder

The digital recorder of the X-Line is working without any paper, and it can be equipped with a digital interface, just like the con­troller. Due to corresponding transmitters, recording and control can be executed in areas being not explosion-proof.
Order No.: X9990-01


EX Options Tubular port

Tubular port

A 45 mm duct in the side panel allows insertion of measuring lines and hoses into the test room. Delivery including cover.
Order No.: X9930-01


EX Options Closing plug

Closing plug

Gas-tight closing plug, matching to the tubular port. The gasket system with a flexibility in the range of 4 mm to 23 mm is based on a rubber module with removable skins and can be adapted to the cables, tubes etc. in different sizes.

Order No.: X9930-02


EX Options Lenkrollen

Steering rollers

Mobile version of the test cabinet with 4 steering rollers, 2 of them lock-type with brake.
Order No.: X9930-04


Technical ventilation

If an evaporation of solvents cannot be avoided by procedural means, a technical ventilation is compulsory. The ventilation prevents the formation of a permanent explosive atmosphere (zone 0). Its efficiency is supervised redundantly by two flow switches. Depending on the density, the gases will be exhausted out of the unit either at ceiling level or at floor level. The air supply is effected vice-versa, at floor level or at ceiling level, to ensure, that the air flow covers all areas of the room. The fan ensures a high ventilation rate.
Order No.: X9980-01


Humidification

Equipped with the options humidification and dehumidification, an explosion-proof cold-heat test cabinet becomes an explosion-proof climatic test cabinet. Humidification of the Safety T-Line is effected by a specially controlled ultrasonic atomizer. Humidification of the Safety X-Line is realized by an explosion-proof version of evaporation humidification being installed in the test room. A plate heat-exchanger of stainless steel, which is optimized for this application, effects a dehumidification by falling below dewpoint. This combination of humidification and dehumidification allows a wide range of temperature/humidity combinations. The sensor is a temperature-compensated, capacitive sensor, which can be calibrated.